Nowadays, many metal processing plants have replaced them with 3000W fiber laser cutting machines that are more efficient and cost-saving. Some novices do not know much about the new machines, and there are often misoperations. So when novices operate 3000W fiber laser cutting machines, machine, what should you pay attention to?
3015 light 3000W Fiber Laser Cutting machine
1. The operator must strictly abide by the safe operating procedures of the 3kw fiber laser cutting machine.
2. The operator must read all the instructions that come with the machine or receive pre-job training from engineers of the laser cutting machine manufacturer, be familiar with the structure and performance of the equipment, and master the relevant knowledge of the operating system.
3. Wear labor protection equipment according to regulations, and you must wear protective glasses that comply with regulations when near the laser beam.
4. Do not process a certain material before knowing whether it can be processed by a 3kW fiber laser cutting machine to avoid the potential danger of smoke and vapor.
5. When starting to cut, blow for 5-10 seconds to prevent cutting without auxiliary gas.
6. When the 3 kilowatt fiber laser cutting machine is started, the operator is not allowed to leave the post without authorization or leave it to someone else to take care of it.
7. Keep the fire extinguisher within easy reach; turn off the laser or shutter of the 3kW fiber laser cutting machine when not processing; do not place paper, cloth or other flammable materials near the unprotected laser beam.
8. When an abnormality is discovered during processing, the machine should be stopped immediately and the fault should be eliminated or reported to the supervisor in a timely manner.
9. When using gas cylinders, avoid damaging wires, water pipes and air pipes to avoid electric leakage, water leakage and air leakage. The use and transportation of gas cylinders should comply with gas cylinder inspection procedures. Do not expose the cylinder to the sun or near a heat source. When opening the bottle valve, the operator must stand on the side of the bottle mouth.
10. Customers who have been trained by the company’s professionals should record the disassembly process when replacing the collimating lens or focusing lens, and pay special attention to the installation direction of the lens, and do not install it incorrectly; customers who have not been trained by the company’s professionals are not allowed to do so without permission. Replace the collimating lens or focusing lens.
